Original battery 2018mAh byara iPhone SE 2022 661-25890 Service Pack

Original 2018mAh Battery for Apple iPhone SE 2022 A2783 A2595 A2782 A2784 A2785 661-25890 Service Pack

The original Apple Service Pack battery with part number 661-25890 is designed for the third-generation iPhone SE 2022, model A2783 for Spain and variants A2595, A2782, A2784 and A2785. This 2018 mAh replacement restores the device's battery life when the installed battery shows wear, rapid discharge, unexpected shutdowns or reduced capacity. Its design and connection correspond to the device's power system, providing a suitable solution for replacement procedures performed by professional repair technicians. It is intended to restore charging and discharging functionality using an original Apple component.

Specifications

Original Apple Service Pack battery with a capacity of 2018 mAh, a nominal voltage of 3.88 V and lithium-ion (Li-ion) technology.

Identified by part number 661-25890 and battery model A2819.

Compatible with the third-generation Apple iPhone SE 2022, models A2783, A2595, A2782, A2784 and A2785.

Its design allows the deteriorated battery to be replaced while maintaining the electrical and connection characteristics corresponding to the device.

As an original Service Pack battery, it maintains the electrical specifications and format intended for the third-generation iPhone SE. Its nominal capacity of 2018 mAh and voltage of 3.88 V allow the deteriorated unit to be replaced without using batteries with a different capacity. Part number 661-25890 makes it easier to identify the correct replacement in professional repair environments and reduces selection errors compared with previous iPhone SE generations, whose batteries are not interchangeable. Furthermore, its compatibility with Apple's Repair Assistant allows component calibration to be completed and its status recorded in iOS when the procedure requirements are met. A solution designed for safe, verifiable and professional repairs.

Installation Tips

Replacement should be performed by qualified technicians using appropriate tools and protection against electrostatic discharge (ESD).

Power off the device, disconnect the existing battery and carefully remove the mounting adhesives, avoiding punctures, deformation or damage to internal components.

Clean off adhesive residue and use suitable new fixings. Align the battery connector without forcing the flex cable and check that it is properly connected.

Perform a power-on, charging and battery recognition test before final closure. Replace the screen sealing adhesive during assembly.

Once installation is complete, it is recommended to finish calibration using Apple's Repair Assistant.

Notice

To correctly complete recognition of this original battery in iOS, it may be necessary to run Apple's Repair Assistant.

The device must have an updated version of iOS, a Wi-Fi connection and a battery level above 20% to start the procedure.

Calibration is performed through Settings, General, About and Parts and Service History.

If the procedure is not completed, iOS may display a pending repair or fail to identify the component correctly. Recognition as an original part depends on successful completion of the calibration process.

Technical Table