Proximity light sensor flex by Motorola Edge 60 Fusion 5G premium quality

Light and Proximity Sensor Flex for Motorola Edge 60 Fusion 5G XT2503-4 Premium Quality

Light and proximity sensor flex for Motorola Edge 60 Fusion 5G XT2503-4 in premium quality, designed to replace the flexible circuit associated with these sensors when it has cuts, damaged contacts or irregular operation. The European variant of the Motorola Edge 60 Fusion corresponds to technical model XT2503-4, and the device features a proximity sensor and ambient light sensor. This replacement part is intended to restore communication between the sensors and the device and facilitate a professional repair with testing before closure.

Premium quality provides good flexibility, precise contacts and proper fitting inside the Motorola Edge 60 Fusion 5G XT2503-4. This replacement part is suitable when the proximity sensor does not respond correctly during calls, automatic brightness adjustment shows anomalies or the associated flex has physical damage after a repair. Motorola confirms the presence of separate proximity and ambient light sensors in this device. It is recommended to inspect the connectors, avoid sharp folds and check both proximity detection and brightness response before reinstalling the internal protections.

Installation Tips

Disconnect the battery and use ESD protection.

Remove the damaged flex without pulling directly on the flexible circuit.

Clean and inspect the connectors before installing the new replacement part.

Avoid bending, marking or piercing the flex during installation.

Check the proximity sensor during a call.

Verify automatic brightness response before final closure.

Notice

Perform proximity and ambient light tests before closing the device. Operation may also be affected by an incorrectly installed display, dirt in the sensor area or problems with the associated connectors.

Technical Table