PTZ protective cover by DJI Neo 2 premium quality

PTZ protection housing for DJI Neo 2 premium quality

PTZ protection housing for DJI Neo 2 in premium quality designed to replace the cover that protects the stabilized camera system, gimbal or PTZ axis area of the drone. This replacement helps protect the camera movement, support and stabilization elements against impacts, accidental pressure, scratches, deformation or wear from use. Its design is intended to be installed in the original DJI Neo 2 location, maintaining the body fit and allowing structural protection to be restored without interfering with movement or stability of the optical module.

Compatible with DJI Neo 2. Recommended replacement for repair services, specialized workshops and repairs where the PTZ housing is damaged, marked, broken or has lost fixing. Replacing it improves protection of the camera assembly and helps keep the drone exterior finish in proper condition after repair.

Specifications

• PTZ protection housing
• Compatible with DJI Neo 2
• Installation in the stabilized camera system area
• Replacement for protection of the PTZ module, gimbal or camera axis
• Premium quality
• Part No:

Premium quality provides good fitting, suitable rigidity and correct integration with the DJI Neo 2 structure. Its main function is to protect the PTZ system against light impacts, friction and handling during transport, maintenance or continuous use. A deteriorated housing can leave the stabilization area exposed, cause looseness or affect the drone visual finish, so replacement is recommended when it shows breakage, deformation or damaged anchors.

Designed for professional repairs seeking to maintain protection, structural precision and reliability of the DJI Neo 2. Available for immediate shipping from Spain.

Installation tips

Disconnect the battery before handling the drone.

Use proper tools to avoid marking the housing or PTZ system.

Remove the damaged part without forcing tabs, screws or anchoring areas.

Clean the mounting area before installing the new housing.

Check that the part is properly seated and without looseness.

Verify that it does not interfere with gimbal movement or the camera.

Technical table