Rear camera connection flex for Blackview XPLORE 2 5G premium quality

Rear camera connection flex for Blackview XPLORE 2 5G premium quality

Rear camera connection flex for Blackview XPLORE 2 5G in premium quality, designed to restore internal communication between the rear camera assembly and the device board. This spare part helps solve faults related to rear camera not detected, black image, intermittent disconnections, errors when switching between sensors, signal loss or damage caused during a previous repair. The Blackview XPLORE 2 5G incorporates a rear camera system with main sensor and night vision, so this flex must be handled with special care to avoid bends, excessive pressure or incorrect seating in the connector. Spare part aimed at technicians and repair services that need to restore the electrical stability of the rear camera module.

Specifications

Brand Blackview

Compatible model Blackview XPLORE 2 5G

Component rear camera connection flex

Quality premium

Location internal rear area of the device

Function connection between rear camera and main board

Premium quality guarantees correct fit, good electrical continuity and stable assembly inside the chassis. This flex is intended for repairs where the rear camera stops working correctly due to cable breakage, connector damage, poor communication with the board or handling during disassembly. Its installation allows restoring detection of the rear module, improving image stability and ensuring correct camera operation in system applications. Before closing, it is recommended to check the main camera, night vision if applicable, switching between sensors, focus, video recording and absence of errors in the camera application. Available for immediate shipping from Spain.

Installation tips

Disconnect the battery before handling the flex.

Use ESD protection throughout the repair.

Check the condition of the board connector and the camera module.

Align the flex without bending or forcing it.

Avoid direct pressure on the contact areas.

Test the camera cold before closing the chassis.

Verify focus, image, video and camera switching.

Technical table