Sidekey flex by Cubot P90 premium quality

Side button flex for Cubot P90 (P90) premium quality

Side button flex module for Cubot P90 in premium quality, designed to replace the circuit when the device shows volume or power button failure, intermittent response, or complete signal loss when pressing. This replacement integrates a flexible ribbon with micro-switches and model-specific FPC connector, ensuring direct electrical and mechanical compatibility with the Cubot P90 motherboard. It restores physical device control without replacing the chassis or other internal components, optimizing professional repair procedures.

Key Features

• Component type: side button flex
• Integrated micro-switches
• Model-specific FPC connector for Cubot P90
• Compatible with original device architecture
• Direct replacement without structural modification

Premium quality ensures stable signal transmission between physical buttons and motherboard, reducing intermittent failures after installation. The flex is manufactured with suitable conductive tolerances and controlled-flex resistant materials, ensuring electrical continuity and durability. It is intended for workshops seeking post-repair reliability and full restoration of the device’s side controls.

Installation Tips

1. Power off the device and disconnect the battery before repair.

2. Handle the flex using ESD protection.

3. Avoid excessive bending of the ribbon during installation.

4. Properly align the FPC connector before securing it.

5. Test all buttons before final closure.

Technical Table