Night vision back camera by Cubot KingKong 11 premium quality

Rear night vision camera for Cubot KingKong 11 (KingKong 11) premium quality

Rear night vision camera module for Cubot KingKong 11 in premium quality, designed to replace the IR sensor when it shows black image, no signal in night vision mode, or activation failure from the camera application. This replacement integrates a low-light optimized sensor with its flex cable and model-specific FPC connector, ensuring direct electrical and mechanical compatibility with the Cubot KingKong 11 motherboard. It restores night vision functionality without replacing the entire camera assembly, maintaining the original rugged camera system architecture.

Key Features

• Component type: rear night vision camera
• Sensor optimized for low-light capture
• Flex with model-specific FPC connector
• Compatible with Cubot KingKong 11
• Direct replacement without structural modification

Premium quality ensures stable image signal transmission in infrared mode, reducing interference or intermittent failures after installation. The module maintains appropriate parameters for capture in dark environments, restoring the device’s distinctive night vision functionality for technical or outdoor use. It is intended for workshops seeking post-repair reliability and full restoration of the night vision system.

Installation Tips

1. Power off the device and disconnect the battery before repair.

2. Handle the module using ESD protection.

3. Avoid touching the sensor lens directly.

4. Properly align the FPC connector before securing it.

5. Test night vision mode before final closure.

Technical Table