Apple Watch 44mm Serie 5 repuestos

Technical Characteristics of Apple Watch 44mm Series 5

The Apple Watch Series 5 has come up with many improvements over earlier versions. Here are some key features and specifications:

• Smart watch (touchscreen)
• Display: 1.78 inch OLED capacitive
• Resolution: 448 x 368 pixels
• Always-on display
• Weight: 47.8 g
• ECG certified (region dependent SW application; HW available on all models)
• Materials: Stainless Steel frame; all-ceramic/sapphire crystal back

Spare Parts for Apple Watch 44mm Series 5

The parts most commonly replaced in the Apple Watch Series 5 are as follows:

• Screens
• Batteries
• Digitizers
• Force touch sensors

Replacement Instructions

Screen and Digitizer Replacement

This is a difficult process. Be careful to avoid injury or damage to your watch.

• Power off the Apple Watch.
• Remove the band from each side of the Apple Watch body.
• Using a Y000 driver, remove the tri-point screws from each end of the display
• Slowly lift the display from the top, separating it from the body with a plastic opening tool.
• Disconnect the digitizer cable connector by prying it away from its socket on the motherboard
• Remove the display.
• Following the same steps in reverse, connect the new screen and reassemble the Apple watch. Remember to not tighten the screws a lot.

Battery Replacement

The battery replacement process is similarly delicate.

• Follow the same steps to remove the display.
• Using a T2 Torx driver, remove the four Torx screws around the battery.
• Carefully lift the battery and disconnect the battery connector.
• Finally, replace the old battery with a new one. Reverse the previous steps to reassemble your Apple Watch.

Note: Be sure to power on your device to test your repair before you reinstall adhesives and close your device.