Apple Watch 44mm Serie 5 repuestos

    There are 17 products.

    Technical Characteristics of Apple Watch 44mm Series 5

    The Apple Watch Series 5 has come up with many improvements over earlier versions. Here are some key features and specifications:

    • Smart watch (touchscreen)
    • Display: 1.78 inch OLED capacitive
    • Resolution: 448 x 368 pixels
    • Always-on display
    • Weight: 47.8 g
    • ECG certified (region depe...

    Technical Characteristics of Apple Watch 44mm Series 5

    The Apple Watch Series 5 has come up with many improvements over earlier versions. Here are some key features and specifications:

    • Smart watch (touchscreen)
    • Display: 1.78 inch OLED capacitive
    • Resolution: 448 x 368 pixels
    • Always-on display
    • Weight: 47.8 g
    • ECG certified (region dependent SW application; HW available on all models)
    • Materials: Stainless Steel frame; all-ceramic/sapphire crystal back

    Spare Parts for Apple Watch 44mm Series 5

    The parts most commonly replaced in the Apple Watch Series 5 are as follows:

    • Screens
    • Batteries
    • Digitizers
    • Force touch sensors

    Replacement Instructions

    Screen and Digitizer Replacement

    This is a difficult process. Be careful to avoid injury or damage to your watch.

    • Power off the Apple Watch.
    • Remove the band from each side of the Apple Watch body.
    • Using a Y000 driver, remove the tri-point screws from each end of the display
    • Slowly lift the display from the top, separating it from the body with a plastic opening tool.
    • Disconnect the digitizer cable connector by prying it away from its socket on the motherboard
    • Remove the display.
    • Following the same steps in reverse, connect the new screen and reassemble the Apple watch. Remember to not tighten the screws a lot.

    Battery Replacement

    The battery replacement process is similarly delicate.

    • Follow the same steps to remove the display.
    • Using a T2 Torx driver, remove the four Torx screws around the battery.
    • Carefully lift the battery and disconnect the battery connector.
    • Finally, replace the old battery with a new one. Reverse the previous steps to reassemble your Apple Watch.

    Note: Be sure to power on your device to test your repair before you reinstall adhesives and close your device.

    Less
    More
    Showing 1 - 17 of 17 items