Asus Zenpad 10 Z301ML spare parts

Asus Zenpad 10 Z301ML Repuestos - Technical Characteristics

The Asus Zenpad 10 Z301ML tablet, due to its complexity, carries a variety of distinct parts. This guide will list the main replacement parts (repuestos) and their technical characteristics.

• Display: 10.1 inches, 1280 x 800 pixels.
• Processor: MediaTek MT8735A Quad-Core, 1.3 GHz.
• RAM: 2 GB or 3 GB.
• Storage: 16 GB, 32 GB, 64 GB (expandable with MicroSD).
• Battery: Li-Po 4680 mAh, Non-removable.
• Rear Camera: 5 MP.
• Front Camera: 2 MP.

Instructions for Replacing Asus Zenpad 10 Z301ML Repuestos

Before getting started, make sure you have a Phillips head screwdriver, a plastic opening tool, tweezers, and a heat gun.

Replacing the Battery:

Disassembling or replacing the battery of your Asus Zenpad 10 can improve its lifespan if it's not holding charge as it used to. Here's how:

• Turn off your device and unplug it from any power source.
• Remove the back cover of the device using the plastic opening tool. Apply slow pressure and work your way around the edges.
• Once the back cover is off, you will see the battery. It is secured with adhesive, so you might need to use the heat gun to loosen it. Be careful to not overheat the device.
• Using plastic tweezers, gently unplug the battery connector from the motherboard, then gently lift the battery off.
• Replace with a new battery and reassemble your device following these steps in reverse.

Replacing the Display:

If your screen is broken or has dead pixels, you might need to replace it. Here's the process:

• Turn off your device and unplug it.
• Start by removing the back cover with a plastic opening tool as before.
• Once you're in, you will need to disconnect the ribbon cables that are connecting the screen to the motherboard. Be very gentle during this step as these cables are fragile.
• Using the heat gun, loosen the adhesive holding the screen, then gently lift it off. Use the plastic opening tool if necessary.
• Place the new screen on, ensuring it is properly aligned. Attach the ribbon cables back to the motherboard, put the back cover back on, and turn on your device to test the new screen.

Note: Always wear safety glasses and work in a well-ventilated area when repairing your device. If you are not comfortable with conducting these repairs yourself, seek assistance from a professional.