Type C USB connector A version by Nintendo Switch 2 premium quality

USB Type-C Connector for Nintendo Switch 2 Premium Quality Version A

USB Type-C Version A connector for Nintendo Switch 2 BEE-001 in Premium quality, designed to replace a damaged USB-C port with looseness, damaged contacts or connection problems. This replacement part helps restore the physical and electrical connection of the port when there are charging, power or cable communication failures. It is prepared for board mounting by soldering, maintaining suitable dimensions for correct alignment with the corresponding assembly. Designed for professional electronic repair and complete port testing before final assembly.

Specifications

USB Type-C connector.

Version A.

Compatible with Nintendo Switch 2.

Technical model BEE-001.

Component for board mounting.

Charging, power and communication function via USB-C.

Requires soldering for installation.

Premium quality.

Premium quality provides precise manufacturing tolerances and stable electrical contacts to correctly restore the operation of the USB Type-C port of Nintendo Switch 2. This connector is suitable for consoles with charging problems, intermittent connection, physical looseness, damaged pins or damage caused during previous repairs. Its design allows only the affected connector to be replaced without the need to replace other functional components of the board. It is intended for technical services with microsoldering experience looking for precise positioning, a firm connection and a reliable repair that reduces possible repeat failures.

Warning

There are two different versions of this USB Type-C connector for Nintendo Switch 2, Version A and Version B.

This product corresponds exclusively to Version A.

Versions A and B are not interchangeable. Before purchase or installation, physically compare the connector with the original part of the device and verify that it corresponds to Version A.

Installation Tips

Completely disconnect the battery before working on the board.

Use ESD protection throughout the repair.

Check that the original connector corresponds to Version A before removing it.

Remove the damaged connector using suitable microsoldering tools.

Avoid applying excessive heat to the board and nearby components.

Inspect the condition of pads and tracks before installing the new connector.

Correctly align all contacts before final soldering.

Check continuity and absence of short circuits.

Perform charging and connection tests before final closure.

Technical Table