Vibrator by Oppo Reno 13 F 5G CPH2699 Oppo Reno 13 FS 5G Oppo Reno 13A 621036000459 Service Pack

The vibration motor for Oppo Reno13 F 5G, Reno13 FS 5G and Reno13 A, all identified by technical model CPH2699, is a Service Pack replacement component with part number 621036000459. This vibration motor generates the phone's vibration alerts and the haptic feedback available according to its configuration. It is designed to replace the component when it stops producing vibrations, operates intermittently or shows physical damage. Replacing it allows technicians to work specifically on the vibration system while preserving the remaining modules that are in good condition.

- Brand: Oppo.

- Compatible models: Oppo Reno13 F 5G, Oppo Reno13 FS 5G and Oppo Reno13 A.

- Technical model: CPH2699.

- Component: Internal vibration motor.

- Quality: Service Pack.

- Part Number (Part No): 621036000459.

- Component type: Electromechanical vibration motor.

- Location: Inside the device.

- Function: Generation of vibrations for incoming calls, notifications and haptic feedback supported by the system.

- Compatible variants: Internationally marketed Reno13 F 5G and Reno13 FS 5G, and Japanese-market Reno13 A, corresponding to model CPH2699.

- Application: Replacement of a deteriorated, damaged or malfunctioning vibration motor.

The Service Pack vibration motor 621036000459 is identified by a specific part number shared by the Oppo Reno13 F 5G, Reno13 FS 5G and Reno13 A. This correspondence simplifies replacement part selection in workshops handling different commercial names for the same technical model CPH2699.

Replacing the motor restores vibration alerts for calls and notifications, as well as available haptic feedback, when diagnosis confirms a fault in the component. As a targeted repair, it avoids replacing parts that are not involved in the malfunction.

It also makes it easier to check the installation using the phone's vibration settings before completing the final closure of the device.

- Turn off the device, disconnect the battery and use ESD protection before starting the repair.

- Carefully disassemble the necessary components to access the vibration motor.

- Compare the shape, electrical contacts and mounting points of the new component with the removed part.

- Remove the damaged motor while avoiding damage to contacts, connectors and nearby electronic components.

- Clean the installation area and remove adhesive residue where applicable.

- Position the new vibration motor according to its original orientation and mounting position.

- Check that the electrical contacts are correctly aligned and that the motor is properly seated in its housing.

- Temporarily reconnect the battery and verify operation using the device's vibration settings.

- Check vibration alerts for calls, notifications and tactile feedback before final closure.

- Replace the adhesive materials of disassembled parts when necessary and complete the assembly.