Battery BLP981 by OPPO Reno8 T 5G CPH2505 OPPO A1 Pro PHQ110 4800 mAh premium quality

BLP981 Battery for OPPO Reno8 T 5G CPH2505 OPPO A1 Pro PHQ110 4800 mAh Premium Quality

BLP981 battery for OPPO Reno8 T 5G CPH2505 and OPPO A1 Pro PHQ110 in premium quality, designed to restore the autonomy, charging stability and energy performance of the device. This replacement part allows replacing a degraded, swollen or charging-fault battery while maintaining the correct internal fit inside the chassis. It incorporates typical capacity of 4800 mAh, nominal voltage of 3.87 V and power of 18.57 Wh. Designed for professional installation, prior charging test and verification before final closure of the terminal.

Premium quality offers stable behavior in charge and discharge cycles, good energy retention and secure connection with the device board. It is a suitable solution for workshops looking for a reliable repair, with a good balance between capacity, durability and mounting precision. It helps restore lost autonomy, reduce unexpected shutdowns and improve the terminal response in daily use. It is always recommended to check the BLP981 reference printed on the removed battery, as well as the exact technical model of the device, before installing the replacement part. Available for immediate shipping from Spain.

Installation tips

Disconnect the battery before handling the terminal.

Use ESD protection throughout the repair.

Remove old adhesives without damaging the chassis.

Do not bend or press the cell during assembly.

Check the BLP981 reference before installation.

Perform a charging test before closure.

Verify temperature, charge percentage and stability.

Calibrate the battery with a full cycle after installation.

Notice

Before installation, always check the battery fitted in the terminal. Some OPPO models may present regional variants or different internal references depending on the marketing area. Always compare the reference printed on the original battery, the technical model of the device, the flex and the connector position before carrying out the final assembly.

Technical table