Camera lens by Cubot P90 premium quality

Camera lens glass for Cubot P90 (P90) premium quality

Rear camera protective glass for Cubot P90 technical model P90, designed to replace the outer lens when it shows cracks, deep scratches, or loss of transparency affecting image quality. This premium quality replacement ensures exact fit over the original module, maintaining proper alignment with the lenses and rear housing. It is a specific technical solution to restore protection of the optical assembly without replacing the complete camera module, optimizing repair cost and time in professional environments.

Key Features

• Component type: rear camera lens glass
• Compatible with Cubot P90
• Precise fit over original module
• Direct replacement without modifying the camera
• Restores protection and optical transparency

Premium quality ensures proper light transmission to the sensor, preventing distortion, internal reflections, or loss of sharpness after installation. The glass provides resistance against scratches and external pressure, preserving the integrity of the photographic system during daily use. It is intended for workshops seeking a clean and structurally secure repair, restoring both aesthetics and functionality without affecting the performance of the original camera module.

Installation Tips

1. Carefully remove all remnants of the damaged glass.

2. Fully clean the module surface before placing the new glass.

3. Apply dedicated lens adhesive if not pre-installed.

4. Properly align the glass before applying pressure.

5. Test focus and image quality before final closure.

Technical Table