Display by Samsung Galaxy Z Flip5 SM-F731 black touch screen graphite assembly frame GH82-31827A Service Pack

Screen for Samsung Galaxy Z Flip5 5G SM-F731B GH82-31827A with black touch and graphite assembled frame Service Pack (SM-F731B)

Complete display module with touch for Samsung Galaxy Z Flip5 5G, technical model SM-F731B, part number GH82-31827A, supplied as Service Pack with integrated graphite-colored assembled frame. This assembly is intended to replace the original module in cases of flexible panel damage, image issues, touch failures, or problems related to the folding mechanism. As a fully assembled screen with frame, it allows precise installation, proper panel alignment, correct flex routing, and stable open and close behavior, reducing installation time and post-repair issues.

Service Pack quality ensures full compatibility with the Galaxy Z Flip5 hardware and stable operation during both active use and standby. This spare part is intended for professional repair environments, recommended for workshops seeking reliability, accurate assembly, and reduced post-installation incidents. Available for immediate shipping from Spain.

Installation tips

Disconnect the battery before starting the replacement.
Always test the module before final assembly.
Ensure correct routing of the display flex without twisting or tension.
Check frame alignment and uniform folding before sealing the device.
Verify correct screen behavior when opening and closing the phone.

Very important:
After replacing the screen on the Galaxy Z Flip5, magnetic open and close system recalibration is mandatory. This process must be performed using the official Samsung Self Repair Assistant software, with the device updated to the latest available Android firmware. Failure to perform this calibration may cause flickering, screen shutdowns, incorrect wake behavior, or erratic operation that does not indicate a defective screen.

Important about returns:
Returns will not be accepted for screens that have been installed or handled and show issues related to the magnetic opening and closing system caused by missing or incorrect calibration. These behaviors are not considered a screen defect but an incomplete installation procedure.

Notice

Service Pack screens are supplied with the latest firmware preinstalled. To ensure proper image, touch, and sensor performance, the device must be updated to the latest Android version before and after installation.

Technical table