Display lcd by Oppo Reno 4 with black touch screen premium quality

Display for Oppo Reno 4 4G CPH2113 / CPH2119 – Reno 4 5G CPH2091 / CPH2099 + touch black premium remanufactured quality

Display module for Oppo Reno 4 4G (technical models CPH2113, CPH2119) and Oppo Reno 4 5G (models CPH2091, CPH2099), designed to restore visibility, touch response and front structure of the device. This premium remanufactured unit uses an inspected, calibrated and stabilised OLED panel to deliver uniform brightness, balanced contrast and consistent touch sensitivity. The assembly has been refurbished respecting original tolerances, ensuring precise compatibility with all technical variants of Reno 4 4G and 5G. It is a spare part aimed at workshops requiring a reliable module, cold-tested and prepared for professional installation with low recurrence rate.

Key features
• OLED display with integrated touch
• Compatibility with Reno 4 4G (CPH2113 / CPH2119) and Reno 4 5G (CPH2091 / CPH2099)
• Premium remanufactured unit
• Uniform brightness and good colour reproduction
• Refurbished assembly with precise tolerances
• Suitable for extending device lifespan
• Ready for cold testing before closure
• Spare part intended for professional repair

Advantages and quality

Premium remanufactured quality offers sharp image output, responsive touch behaviour and stability in daily use, maintaining an experience close to the original panel. The refurbishment process guarantees a clean surface, stabilised internal layers and proper bonding, reducing risks of later failures. Its design respects the geometry and connector layout of the Reno 4, ensuring secure mounting and correct panel fixation. A professional solution for repair shops seeking durability, reliability and well-executed assembly.

Installation tips

1. Disconnect the battery and use ESD protection.

2. Perform a cold test before sealing the device.

3. Align flex cables without forcing them.

4. Replace adhesives and clean previous residues.

5. Check brightness, touch, sensors and camera.

6. If the device uses in-display fingerprint, calibrate before closure.

7. Apply uniform pressure for 20–30 minutes after sealing.

Technical table