Google Pixel 6A spare parts

Technical Characteristics of Google Pixel 6A Repuestos

The Google Pixel 6A Repuestos comprises of various cutting-edge smartphone components that are known for their superior quality and reliability. Here are the key specifics:

• Display: Flexible OLED, 1080 x 2400 pixels resolution, Corning Gorilla Glass Victus
• Processor: Google's Tensor SoC
• Camera: Dual camera setup at rear (50MP primary + 12MP ultrawide), 8MP front-facing camera
• Battery: Non-removable Li-Po 4614 mAh battery
• Operating System: Android OS v12.0

Instructions on Replacing Google Pixel 6A Repuestos

Replacing components of Google Pixel 6A can be intricate and requires utmost care. It is recommended to follow these instructions precisely:

Tools Required

• Small Phillips Screwdriver
• Opening Picks
• Tweezers
• Spudger

Disassemble the Google Pixel 6A

Before starting, ensure that the phone is switched off. During this process, avoid applying too much pressure on the screen or any other parts as it could result in damage.

• Start removing the two pentalobe screws at the bottom of the device, using the small Phillips screwdriver. Once the screws are removed, set them aside carefully to avoid misplacement.
• Use an opening pick to loosen the adhesive around the edge of the phone's screen. Gently lift up the screen.
• Disconnect the screen connector using the spudger.

Replace the Repuestos

The replacement process may vary depending on the part being replaced. Therefore, follow relevant guidelines per the damaged part. Pay close attention to the connections, orientation, and order of parts as you disassemble the phone.

• Gently remove the damaged repuesto part and replace it with a new one. Ensure that the new part is properly aligned with the correct screw holes or connectors.
• Connect the repuesto to the right slot. Carefully reconnect any flex or ribbon cables that were disconnected.

Reassemble the Google Pixel 6A

Now, it's time to reassemble the phone after the damaged repuesto has been replaced.

• Reconnect the screen and firmly press the display back into place.
• Open the phone and reconnect the battery.
• Fasten the pentalobe screws back into place at the base of the phone using the small Phillips screwdriver.

Note: It's crucial to always remain careful and patient throughout the process, and never force any parts in or out. Wherever in doubt, seek professional help.