Front cover black by Cubot A40

Front housing or front frame black for Cubot A40

The front housing or front frame in black for Cubot A40 is designed to replace the front structure when the original shows breaks, deformations, loss of rigidity, cracked mounting points or wear caused by continuous use. This replacement restores the device’s structure, ensuring proper screen support, correct button alignment, chassis stability and secure positioning of the internal components that depend on the frame to remain fixed during daily use.

Its manufacturing respects the specific tolerances and geometry of the Cubot A40, providing a clean, solid fit fully compatible with the device’s design. The black finish reproduces the original appearance, offering durability and resistance against minor impacts. It is an essential replacement when the frame is bent, loose or damaged, since a compromised front structure can affect screen assembly, cause gaps and reduce the device’s lifespan.

Installation advice

1. Power off the device before starting the procedure.

2. Use ESD protection during the entire repair.

3. Remove the damaged frame without forcing internal tabs or retaining clips.

4. Clean adhesive residues, dust or deformations from the chassis edge.

5. Install the new frame ensuring correct alignment with the screen and side buttons.

6. Verify that no gaps remain and that all components fit correctly before finishing.

Technical table