Front cover black by Cubot P90

Front housing or front frame black for Cubot P90

The front housing or front frame in black for Cubot P90 is designed to replace the front structure when the original shows breaks, deformations, worn mounting points or loss of rigidity caused by continuous use. This replacement restores the device’s structural firmness and ensures proper screen support, precise button alignment and overall chassis stability, all essential to prevent gaps and extend the device’s lifespan.

Its manufacturing respects the specific tolerances of the Cubot P90, providing a solid, clean fit fully compatible with the device’s design. The black finish faithfully reproduces the original appearance of the model, allowing the front to regain its uniform look without compromising internal components. It is a key part in repairs where the frame is bent, loose, cracked or damaged in a way that affects proper screen assembly.

Installation advice

1. Power off the device before starting the procedure.

2. Use ESD protection throughout the repair.

3. Remove the damaged frame without forcing internal tabs or clips.

4. Clean adhesive residues, dust or deformations from the chassis edge.

5. Install the new frame ensuring correct alignment with the screen and side buttons.

6. Verify that no gaps remain and that all components fit correctly before finishing.

Technical table