Power and fingerprint blue by iPad Air 11 2024 iPad Air 11 2025 iPad Air 13 2024 iPad Air 13 2025 premium

Blue Power and Fingerprint Sensor Flex for iPad Air 11 2024 A2902 A2903 A2904 iPad Air 11 2025 A3266 A3267 A3270 iPad Air 11 2026 A3459 A3460 A3463 iPad Air 13 2024 A2898 A2899 A2900 iPad Air 13 2025 A3268 A3269 A3271 iPad Air 13 2026 A3461 A3462 A3464 Premium Quality

Power button and fingerprint sensor flex for Apple iPad Air 11 2024 M2, iPad Air 11 2025 M3, iPad Air 11 2026 M4, iPad Air 13 2024 M2, iPad Air 13 2025 M3 and iPad Air 13 2026 M4 in premium quality and blue finish. This replacement integrates the top button and Touch ID sensor into a single flexible assembly, designed to replace damaged modules or units with irregular operation. Compatible with the variants indicated in the technical table and prepared for professional installation and cold testing before closing the chassis.

Specifications

Component: power flex with integrated Touch ID fingerprint sensor.

Function: power on, power off, lock, wake and fingerprint sensor management.

Location: top button of the device.

Connection: flex with FPC connector.

Color: blue.

Compatibility: 11 and 13 inch iPad Air models from the indicated 2024, 2025 and 2026 generations.

Premium quality provides precise fitting, stable button travel and reliable electrical continuity for a professional repair. Its design maintains the geometry, fixing points and connector position required to facilitate installation inside the chassis without modifications. It is designed to replace damaged flex cables, power buttons with irregular response or assemblies affected by wear, impacts or previous repairs. Its assembly precision facilitates clean installation and helps reduce repeat repairs in the workshop. It is recommended to check power, lock, button operation and assembly functionality before final closure. Available for immediate shipment from Spain.

Installation Tips

Disconnect the battery before handling the flex.

Use ESD protection throughout the repair.

Remove the installed assembly without bending or puncturing the flex.

Align the FPC connector without applying excessive pressure.

Perform a cold test before closing the device.

Check power, lock, button operation and sensor functionality.

Replace the necessary adhesives before final closure.

Technical Table