PolarTronix FL-101 Lead-Free Solder Flux Paste For PCB and BGA Repair 10cc 16g

PolarTronix FL-101 soldering flux paste is a lead-free and halogen-free flux, supplied in a 10 cc syringe and marketed in a 16 g format. It is designed for microsoldering, maintenance and repair of PCB boards and SMD, BGA and CSP components. Its No-Clean, low-residue and low-smoke formulation promotes solder wetting and helps reduce oxidation during the soldering process. Its paste consistency facilitates localized application to contacts and electronic circuits, making it particularly useful for professionals repairing mobile phones, computers and gaming consoles.

- Brand:PolarTronix.

- Model:FL-101.

- Product type:electronic soldering flux paste.

- Formulation:lead-free and halogen-free.

- Technology:No-Clean, low-residue.

- Activity:highly active flux.

- Electrical conductivity:non-conductive.

- Smoke emission:reduced during soldering.

- Consistency:smooth paste for localized application.

- Container capacity:10 cc.

- Declared commercial quantity:16 g.

- Packaging:dispensing syringe for precision application.

- Main function:promote solder wetting, facilitate solder flow and reduce oxidation during heating.

- Applications:repair and rework of PCB boards, SMD, BGA and CSP components, connectors and electronic circuits.

- Devices:mobile phones, tablets, computers and gaming consoles.

- Professional use:microsoldering, motherboard repair, component replacement and electronic maintenance.

PolarTronix FL-101 flux paste facilitates microsoldering operations thanks to its active formulation, which promotes solder flow and improves wetting on metallic surfaces. Its smooth consistency allows small amounts to be applied directly to contacts, pads and electronic components, providing greater control during precision repairs.

No-Clean technology reduces residue accumulation after soldering, while its halogen-free and electrically non-conductive formulation is suitable for work on electronic circuits.

Its 10 cc syringe packaging facilitates accurate flux dispensing and helps optimize consumption. It is a practical solution for repair shops performing connector replacement, PCB board repairs, work on BGA components and electronic device maintenance.

- Completely disconnect the power supply and battery of the device before working on the electronic board.

- Use appropriate microsoldering tools and electrostatic discharge (ESD) protection.

- Clean the soldering surface beforehand to remove dirt, residue and remaining old flux.

- Apply a small amount of PolarTronix FL-101 paste directly to the contacts or area to be soldered.

- Use a soldering iron or hot air station at a temperature appropriate for the component and solder alloy being used.

- Distribute the solder in a controlled manner to achieve uniform joints and avoid accumulation between nearby contacts.

- Inspect the solder joints after the process to check their correct formation.

- Perform additional cleaning with a suitable product when required by the repair procedure or desired finish.

- Check the operation of the repaired circuit before completing device assembly.