Realme

Technical Characteristics of Realme

Realme is known for producing exemplary smartphones that balance affordability and functionality. Here are some technical characteristics for typical models in the Realme lineup. Please note characteristics may differ slightly depending on the specific model.

• Operating System: Android based Realme UI
• Processor: Different models might house MediaTek or Snapdragon processors
• Storage: Varies between models, with options from 32GB up to 256GB
• RAM: Ranges between 2GB to 12GB depending on the model
• Camera: Multi-camera setup with features like super nightscape, ultra wide mode, bokeh effect etc.
• Display: Full HD+ resolution in most models with corning gorilla glass protection
• Battery: Varying from 4000mAh to 6000mAh in capacity, often with fast charging capabilities
• Connectivity: 4G, Wi-Fi, Bluetooth, GPS, USB Type-C and more.

Instructions for Replacing Realme parts

Please note that replacing parts on your device should be taken seriously. It's recommended you follow the steps precisely and use the proper tools. Safety should always be your top priority.

Before you start

• Switch off your Realme device and unplug from any power sources.
• Prepare your clean, flat workspace with the necessary tools: small Phillips head screwdriver, plastic opening tools (spudgers), tweezers, and a heat gun.

Screen Replacement

• Heat the edges of the screen gently with a heat gun to soften the adhesive.
• Use a plastic opening tool (spudger) to pry the screen off, starting from the bottom. Be careful not to damage the flex cable.
• Detach the ribbon cable that connects the screen to the body of the phone.
• Replace the old screen with a new screen. Connect it using the ribbon cable, and make sure it fully adheres to the phone surfaces.
• Power the device to check if the new screen works properly before reassembling.

Battery Replacement

• After removing the screen, you should see the battery. Observe the screws surrounding the battery. Unscrew them using your Phillips head screwdriver.
• Use the plastic tool to gently lift the battery out of its recess.
• Detach the connector ribbon that attaches the battery to the phone.
• Place the new battery in, connect it, then screw back into place.
• Reassemble the device and power on to test the new battery.

Please note that these instructions are generalized since the replaceable parts depends on the specific Realme model.